Description

sE Electronics spent years mic’ing up bands and touring rigs before building the V3 — and it shows. This is a dynamic mic engineered for the realities of stage and studio life: nights of load-in/load-out, mic stands getting bumped, and vocalists who won’t stand still.

All-metal build: Zinc alloy chassis and a spring-steel mesh grille that won’t dent or corrode. The beveled grille edge also keeps the mic from rolling off an amp cab or stage floor when you set it down.
Gold-plated XLR connector for a solid, corrosion-resistant signal path over years of use.
Internal windscreen tames plosives and wind noise. A spare black windscreen is included if you’d rather skip the signature sE Red.
Custom voice coil and cardioid capsule: Delivers a smooth, natural tone across voices and instruments while rejecting off-axis stage noise, so you get more gain before feedback kicks in.
Neodymium magnet and tight manufacturing tolerances keep sensitivity and tone consistent unit to unit.
Patented shock mount: Decouples the capsule from handling vibration and stand rumble, so an active performer doesn’t translate into noise on the recording or mix.

Whatever you point it at — a cranked guitar cab, a kick drum, or a vocalist working the stage — the V3 stays consistent and dependable.

Included: Microphone, mic clip, thread adapter, black internal windscreen, carrying pouch — plus a free 20′ XLR cable to get you plugged in and playing.

Specs: Dynamic capsule, copper voice coil, neodymium magnet, cardioid pattern, 50 Hz–16 kHz frequency range, 600 Ohms impedance, 2.5 mV/Pa (-52 dB) sensitivity, 3-pin male XLR output, 52 mm diameter x 181 mm length, 295 g weight.