Description

Built around Heil’s acclaimed PR 30 capsule, the PR35 is a dynamic microphone engineered for broadcast, recording, and live sound work where a smooth, flat response across a wide frequency range actually matters. Heil mounted the element in an internal shock mount to keep handling noise and vibration out of your signal, and this bundle throws in a free 20′ XLR cable so you’re not scrambling for one at setup.

The core of the PR35’s sound comes from a large 1 1/2″ low-mass aluminum voice coil paired with a specialized magnet structure. A hum-bucking coil is wound and positioned specifically so the mic can sit close to video monitors without picking up hum or buzz — a real consideration for broadcast and streaming setups. The phasing plug uses evenly spaced ports that capture rear-facing audio out of phase, which tightens up the cardioid pattern, cuts proximity effect, and keeps articulation clean and consistent across the 40 Hz-18 kHz frequency response. The element handles high SPL without overloading and runs without phantom or DC power.

An internal low-frequency filter switch (accessible with a small screwdriver or paperclip) lets you roll off audio at 80 Hz at -6 dB/octave when pushed down, or open up the full 40 Hz-18 kHz range when left up. The cardioid pattern rejects unwanted sound most strongly at 180 degrees off-axis, directly behind the mic, with minimal off-axis coloration.

3-pin XLR output
Dynamic element with neodymium magnet structure
Output Level: -52.9 dB @ 1,000 Hz
Frequency Response: 40 Hz-18 kHz (filter off) / 80 Hz-18 kHz (filter on)
Impedance: Balanced 600 Ohms, 3-pin XLR
Polar Pattern: Cardioid
Finish: Rubberized matte black
Net Weight: 9 oz
Includes mic clip (fits 5/8″-27 thread) and leatherette carrying case
Free 20′ XLR cable included

Note: amateur radio use requires a separate CC-1 XLR cable to interface with a transceiver.